Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just wondering if anyone has seen this - I had someone call in, they had built a Pub, and then were adding 2nd node to the server, in preparation for installing the Sub. They noticed they had used the wrong name, so they deleted it, and added it aga...
I have a location where we are installing a CM 4.1(3), it has BAT 5.1(4) as plugin, which we installed. It seems fine, until we try to create a template, and it lets you get all the way through the process, until you try to finish - then the panel o...
I happened to notice on one of our new installs that there were 3 lan connections active. My previous encounters with teaming were very clear that you were supposed to install it in Fault Tolerant mode only, so I went to dig up the teaming doc to se...
Hi! We have an implementation with CME and Unity, and have a few call handlers built in Unity to direct call flows. This works fine if an IP Phone caller ends up in a call handler, makes a selection, and gets xfered to the destination defined in 'c...
I have someone upgrading their Call Managers tonight, from 3.3.2 to 3.3.3, and they have a number of Attendant Console clients running. They will go from AC 1.1.3 to 1.2.1, and I know we need to upgrade the clients, but I am wondering if the old cli...
This can get a little squirrely, but you can try using a sip profile. I have used this to change messaging from one leg to another (changing a response to a message that came in on provider side, went out to cucm, response came back from cucm, this ...
I would suspect something to do with the fact that this is not exactly a call, following that dial peer out of the box. You could try applying that profile globally, under voice service voip, sip area...
Mary Beth
