Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
good day everybody, I'm having a problem with calls fom PSTN to VoIP phones. There is a cheme PSTN (Nortell) ----> Cisco 2911 (gateway) ----> Cisco C2600-IX-M (Gatekeeper) ----> CUCM 8.6 Calls from VoIP phones to PSTN works just fine. When PSTN user ...
Good day. I have an issue with transferring incoming call from PSTN. I'm using CME on UC560 platform. Sorry for not posting configuration (too big). Please tell which section should I post to help you understand situation. There are common configurat...
Good day colleagues. I'm having issue with subinterfaces. I've connected two routers and created subinterfaces on both ends. I configured both sides but can't ping neighbor router. More than that I can't ping local address on subinterface. Pleace che...
Hello everybody,We have built our network core with Juniper EX8216. But Juniper works terrible and we facing big problem with that. So I'm looking for advice which device can be placed instead of Juniper EX8216. I'll tell you what I'm looking for mor...
GW did cutting off and translate last four digits back to CUCM so phones started ringing. I belive the problem was to sent signaling back to PSTN and start voice flow.
Good day Nishat.First of all thanks for your help. I thought there is a problem with signaling or transcodding. However problem had a few pieces. VoIP site have prefix 2075XXX (207 is a techprefix ) all phones got DNs 5XXX. CUCM have pattern 2XXXXXX...
Thanks for your help. I have solved this problem. To solve this problem I changed Significant Digits value from all to 4 in Call Routing Information - Inbound Calls section. Best regards,GRinch
Good day Nishant, There are a trunk configuration printscreen and GK config as weel in attachment. Could you please tell how to get datailed trace from RTMT as I not very experienced with that. Thanks
