Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Configured MGCP controlled FXS to FXS call transfer, full-blind. Is it possibleto configure full-consult FXS to FXS call transfer? CM version 7.1.3.Regards,TO
Hi,Some of the 1522 APs disappeared from the main AP list and nowthey are among the rogue APs. Their MAC addresses are addedto Local MAC Filters. What may be the cause of this?WLC IOS - 4.1.192.22M.
Hi,There is no L3 network connection to some of the 1522 APs in our mesh network.They register with the 4402 WLC (5.2.157.0)i.e. appear in the AP list. When sending ping packet to APs IP addresses from WLC or PC there is no response, but I can see AP...
There are several 1522 APs working as mesh (802.11a backhaul) and one Root AP connected to the wired network. One of the mesh APs is also configured as bridge and it connects remote LAN to wired network. Is it possible to place remote LAN traffic in ...
Hi,Phones are registered to CUCUMBE. If phones (i.e. fxs ports) are registered directly to CME how do I transfer calls?Should I use one of the TCL applications?
CME router is working as a voice gateway, its ports are registered to central CUCMBE.What would be your suggestion regarding the design? voice service pots voice service voipvoice-port 0/0/0 supervisory disconnect dualtone mid-call cptone RU ...
Hi,In a branch office there is a 2811 ccme router with MGCP controlled 4 FXS and 4 FXO ports.When there is an incoming call from PSTN or from central office IP phones to one of the analog phonesconnected to FXS port ot the 2811 router I want to be ab...
Today I found out that AP-15 in the following mesh configuration was the source of the problem:No network connection to AP-15 and it's child APs (AP-19, A-17, B-18, B-14,A-16),when testing links with "child" (AP-19) and "parent"(AP-21) APs "Error: C...
