Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a wireless controller 5508 and all my interfaces can be accessed via https or ssh from a wireless client.Management access from a wireless client is disabled so I don't understand why this is happening.Does anyone know how to fix this?Thanks...
Hey guysI have 4 ADSL lines from the same ISP going into one Cisco 887VA router. Does anyone know how can I do load sharing between the 4 lines without getting the ISP involved?At the moment I have route maps and policy based routing but that only wo...
Hi guysI have a wireless network with LWAPPs and 1 WLC 5508. Does anyone know how to block communication between SSIDs (clients in different SSIDs bassically) and whether that is even possible from the controller?I'd like to mention that communicatio...
Hi guysWe have recently been dealing with a situation where we get the above packets and access to one of our applications just hangs.To tell you a bit about our network, hub and spoke topology, with IPSEC GRE tunnels over MPLS, and the application s...
HiI have an ASA5510 and I would like to implement something like this: have two ports patched in and ready but only one active, the other one in standby (when the first one goes down the other port comes up and all the traffic goes down this way), al...
That didn't work I'm afraid. I have disabled the management via dynamic interface but it didn't do the trick.The only way I can stop it is if I go to Management, under HTTP or Telnet-SSH in the GUI and disable it from there but then that cuts off th...
