Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone help me with what I'm missing when it comes to configuring a 2821 router with a NM-16A module for a terminal server.Here is my configip routing!interface ethernet g0/0ip address 10.1.1.3 255.255.255.0!ip host R1 2065 10.1.1.3!ip route 0.0....
I've been reading a bunch of different posts on how to rate limit a 3560 inbound and outbound using different QoS methods. Can anyone narrow it down for me please? I've read about vlan class maps/policy maps, using the rate limit command on the phy...
Hello, I'd like to know if the setup below is a viable configuration for what I'm trying to do. All of the users are on vlan 1 for data and I created some subinterfaces for other networks to work off of. Subinterfaces were created for vlans 20,60,2...
So I'm stuck on something. I'm trying to configure intervlan routing between a cisco 2801 router and HP/Amer switches. Using int fa0/1 and subinterfaces I was sure I had it configured correctly, but I cannot ping the default gateways when I place a...
So I'm having issues getting data to come across this site to site tunnel. The remote site needs us to NAT the destination network because they have an overlap. I hope this makes sense.Remote Endpoint - A.A.A.ARemote LAN - 156.30.x.xLocal Endpoint ...
Hello. The interface is active and I'm able to access the router remotely in that IP. As for the cable, I'm using the octal ones. Whatever its called. CAB-OCTAL-ASYNC
What about adding these commands to the switch?mls qosint vlan 400rate-limit input 5242880 5000 5000 conform-action transmit exceed-action droprate-limit output 5242880 5000 5000 conform-action transmit exceed-action drop
Well I added those ports as tagged on the vlans, no luck. I have all ports untagged on default vlan 1 and on the router the native vlan is on 1 as well. I'm stumped.
