Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It would be handy if I could tell a site "You are going to have a <insert model of switch / MX / whatever> and here is the configuration I want it to have when I claim it. Then when I claim the unit, I can select which pre-made device configuration w...
I have recently started using the capture command in the ASA/PIX. I would like to find some documentation that defines the output fields in the captures. I have searched around quite a bit but am not finding much. Does anyone know of any documentatio...
I have a two questions. First, where can I find some documentation that will help me come up to speed with the configuration steps necessary to deploy the converged features of the 3850. Second, do AP's need to be directly connected to the 3850 or ca...
Toma,Set your router config back to the configuration you first listed, then make FastEthernet0/3/0 a trunk port using the commands that Dan-Ciprian gave you. This will make that interface a trunk port which will carry traffic tagged for any allowed ...
