Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I want to change the severity of the link down alarm in the Cisco Prime Infrastructure 1.3, but in the menu Administration -> System Settings -> Severity Configuration i can not find the alarm. Some body knows where is it? o where i can change th...
Tengo una controladora de modulo en un router 2800 con la version 6.0.202.0 y no he podido actulizar a la version 7.0.98.0 o 7.0.218, cuanto termina de pasar el archivo del tftp y empieza a extraerlo se reinicia el puro modulo de repente. Ya le probe...
My WLCM does not boot, it shows this:Initializing memory. Please wait. 256 MB SDRAM detectedBIOS Version: SM 02.00BIOS Build date: 09/17/02System Now Booting ...Booting from disk..., please wait.Embedded BIOS Debugger Single Step TrapEAX = FFF0FBA4 ...
Hi everyone, i'm trying to do a redundant bridges, with 2 root bridges and 4 non-root bridges. So normaly 2 non-root will connect to a single root, but if one root is down, his two non-root will connect to the other root, and this works fine with the...
Hi, we have Cisco Works LMS and a few days ago, the device center is showing the an error when i introduce the ip address of any device, i attach the screenshot, thanks in advanced.
Hi Scott, do you have a document about the problem when you connect the 8510 with vPC to different Nexus? because we have some issues with that. Or any document when Cisco recommends to connect the 8510 to tha same Nexus.Thanks in advanced,Milton Tiz...
Hi Rollin and Daniel,the first test i did changing the severity was with a new installation, with no devices added and it worked, when i did it in a Prime infrastructure with devices added it didn´t work, well, for this Prime with devices i upgraded ...
Hi Daniel,i finally resolve it, we were looking for the link down alarm for switches and hubs, but on the severity configuration for the category Switch there is an alarm interface operationally down, i don´t know why but by default the severity is i...
Hi rsayakhom, The interfaces of the WLCs should be in the same subnet, but not the same ip address of course, and the warning is becuase the client has the same ip address that the dynamic interface of the wlc.Regards,Milton Tizoc.
