Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dears
ww have mutihomed ISPs where we are receiving the full bgp routes from all of ISPs
case: we have a latency complain to certain destination and need to assur that the selected path ISP having the optimum latency. When we checked, the routed is ...
Dears, we have the attached diagram. I have a problem in the routing between the the two CPEs that are on green VRF, while the red VRF routing is working fine. Even though I have implemented the configuration similar. Note:1- the configuration on...
Dears, Currently, we have a traffic with one upstreamer of 600 Mbps and we are planning to migrate to have another upstreamer to migrate parcial traffic ( 150 Mbps) only to the new upstreamer. How we can acheive this if we will receive the defulat ro...
Dear, Currently, we have one ISP-1 and we are planning to have another ISP-2 ( see diagram): I have a couple of qustion and senario regarding the traffic managment for BGP:1- If the default route form ISP-1 and full BGP table from ISP-2. - I put loca...
Thanks
this is a way where it will change the outbound for the destination, hence if the route is very bad the live traffic will be affected during the testing, I am looking for a best practice technique to do testing without affecting the live tra...
Thanks enrico for you vuable explenation.Yes our router can handle the Fulll BGP traffic as we have 8GB RAM. In case I got the full BGP traffic then I need a traffic visibility e.g netflow to show how my traffic flow to the internet destination Isnt ...
Hi Enrico,BPR can be implemented with tracking but In case there is a problem in certain route or marine cable cut. I think this will not be a practical way to implment.What about if we receive the full BGP route from both upstreamers? In this case, ...
