Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured HSRP on the two RSP MgmtEth interfaces so I can manage the router from the same IP address regardless of the active RSP:
router hsrp interface MgmtEth0/RSP0/CPU0/0 address-family ipv4 hsrp 1 version 1 timers 1 3 ...
Hey allI have an ASR-9010 with MOD160 card running 5.3.1. I defaulted two interfaces and put a new VRF + IP address on them and now they are missing from the command output show ip int brief.I however do see (correct) output when entering the command...
Hey guysAnother ASR9k question from me, this time about power supply redundancy. We connected all eight power supplies on the ASR9010 as can be seen in the picture. The four connectors to the left go to feed A, the four connectors on the right to fee...
Hey allI'm working from the console on a RSP440 in a new ASR9010 chassis using PuTTY (v0.64). I'm experiencing the following issues:Cursor (arrow) keys don't work. Luckily I know about Ctrl+P and Ctrl+N.Pasting in text using the right mouse button do...
Hey guysIs it possible to have the ASR 9010 send out an SNMP trap when a power supply fails or is it only possible to query for this even using SNMP? Gr,Tom
Thank you for your quick response! It seems you also explained it here: https://supportforums.cisco.com/discussion/11840376/use-management-ethernet-port-asr9000
Alexander, you said:
The mgmt interfaces on the RSP are designated out of band. This means that they can't transport user traffic but only management traffic.
Is it possible to convert these mgmt interfaces to inband, like this?
control-plane manage...
Hi Xander
Thank you for the article. I found a Cisco presentation from 2012 on nV Technology and it says on slide 8 that there is a pay-as-you-grow licensing model for the ASR9000v in 11-port increments.
Can you tell us a bit more about this? On the ...
What is the difference between sending a standard break sequence using Control+Break and a special break command using PuTTY?The reason for asking is that my colleague could not send a break using the Control+Break keyboard keys but was able to inte...
