About accurisit

accurisit · 01-21-2013

Hi,As per the attached diagram:How do I configure the 2 ports on the 3560 (Ports 6 & 7) and the connected ports on each of the 2960 switches (Port 25) to provide redundancy.If the uplink from Switch A dies then I need the traffic to flow through the ...

accurisit · 09-23-2010

Hi All,I'm looking for some urgent help please.I have a Cisco 1901 router with 2 onboard Gigabit Ethernet ports that are configured as a BVI due to an unusual config with the ISP (it works!).I also need to route/NAT to from 2 or 3 other subnets and r...

accurisit · 08-16-2010

Hi All,I'm very new to the Cisco environment and am attempting to configure a CISCO 1941 Router (IOS 15) to connect to a newly delivered ISP connection. I was expecting them to configure their device with Private IP addressing between them and me but...

accurisit · 01-22-2013

It's down to 35seconds - Is that about the best I'm going to get?Simon...

accurisit · 01-22-2013

I already made the change.CISCO 2960 SWITCH Aco15-pri-sw#sh cdp neiCapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone, D - Remote, C - CVTA...

accurisit · 01-22-2013

Thanks Alain,CISCO 3560 SWITCH Cisco3560#sh spanning-tree vlan 10VLAN1810 Spanning tree enabled protocol rstp Root ID Priority 34578 Address 3cdf.1ecc.7980 This bridge is the root Hello Time 2 sec Ma...

accurisit · 01-22-2013

The switches are basic L2 2960 models so no option to Stack them.I've amended the diagram to avoid confusion over 'Redundancy' and also to amend the Subnet Mask of the 3560.If I remove the uplink cable from Switch A it takes 30 to 50 seconds for the ...

accurisit · 09-24-2010

This has now been resolved. Not sure if it's the textbook answer but it works.********************************************interface FastEthernet0/0/1 switchport trunk native vlan 20 switchport mode trunkinterface Vlan20 ip address 10.30.1.253 255.255...

Member Since	‎08-16-2010 04:56 AM
Date Last Visited	‎04-11-2018 12:18 AM
Posts	17

User Statistics

User Activity

Help - L2 redundancy config?

Layer 2 HWIC 4 Port routing?

Bridge or VLAN

Help - L2 redundancy config?

Help - L2 redundancy config?

Help - L2 redundancy config?

Help - L2 redundancy config?

Re: Layer 2 HWIC 4 Port routing?