Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear community, we are having an issue activating the ha_cluster in between two on-prem satellites version 7.xrunning provision_standby works just fine on the standy node. but when running ha_deploy from the active node, we see these errors, resultin...
Hi there, anyone of you succeeded in configuring a HA cluster in between two on-prem satellites ver 7.x?We have successfully installed two of these and tried to configure HA as explained in the install_guide. The first step is running ha_provision_st...
Dear community,
Just a quick question. I would like to implement the FQDN ACL feature. The ASA which I am using for this, has a private IP address configured on it's outside if.
Traffic initiated from the inside if's will be static 1:1 natted to ...
Hi there,
I am having trouble testing a new back-to-back vPC setup.
I have two vPC domains connected:
1a(pri) <--> 2a (pri)
1b(sec) <--> 2a (sec)
I have setup some continous pings behind vPC's connected to classical etherchannel switches....
Hi there,
I am trying to find the reason for the high number of input-queue drops on a 2821:
Input queue: 8/150/3790/0 (size/max/drops/flushes); Total output drops: 0
The interface concerned has CEF enabled:
IP fast switching is enabled IP fast sw...
For any interested reader, I have managed to get past this; the pcsd process was running only port 2224 of the IPv6 stack. So after editing the pcsd service file, I've changed it to IPv4 only. Netstat -ln now showed my the pcsd was listening on ipv4:...
I think I've found my issue... going to test it tomorrow... I have configured vpc "peer-switch" but I think i've configured the STP prio's differently in between the primary en secondary.... going to fix that tomorrow and let you guys know.... tbc
The thing I've not mentioned before, the interfaces which handle these packets actually have "ip nat inside" en "ip nat outside" configured. I have not find any info about NAT & CEF but could it be the case that when using NAT (including route-maps ...
Hi Joseph,
The if is running at 1000/full (fixed).
I would like to know if my troubleshooting steps are correct and what kind of packets are meant by "Receive" under "show cef not-cef-switched". And when I have a look at the buffer, why are these UD...
