Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am planning a ASR9K upgrade and I see Cisco recommends to use CSM.
I don't particularly want to execute the upgrade using CSM but after installing version 3.5 on a Fedora VM and installing 2.0 on Windows it would be nice if it could possibly get ...
HIi,I am trying to design a policing strategy/implementation for circuits we provide as a Service Provider, be it internet circuits or EoMPLS circuits (in the future I will have the requirement to do the same for VPLS and L3 IPVPN circuits).All of th...
Hi everyone,I have OSPF as a CE to PE which is up and all looks good, my PE (ASR 9001) has a load of prefixs:RP/0/RSP0/CPU0:POP-01-PE1#sh ip route vrf AO*E1 0.0.0.0/0 [1172/51] via 172.16.214.231, 16:54:21, Bundle-Ether10.214 [1172/51] ...
Hi,I am really struggling with MPP on ASR 9001.I am sure this was working previously but anyway I have an issue where I believe I had MPP configured and working to block ssh connections, I have since brought up BGP with a transit provider and now can...
Hi Guys:I've got a requirement for L2 circuits over an MPLS network and from the customers perspective these need to look like L2 trunks to pass multiple VLANs over, I also need to tunnel STP as one customer is going to have 2 circuits.Topology below...
OK, I have been troubleshooting this; I removed all the control-plane config and I was still able to SSH to ALL interfaces except the mgmt interfaces, so OOB config is working as expected.I added the config back in.I then removed the line: ssh server...
Thanks a lot for the help, when I created a untagged EFP and a xconnect for it it was tunneling untagged frames from my edge switch.The configuration that Dan suggested worked, thanks a lot to you bothSent from Cisco Technical Support Android App
Just to try and summarise the issue:I am trying to get a l2 p2p xconnect configured between Cust Sw1 and Cust Sw2 and the end result I am looking for is that the Cust Switches see the link as a trunk.The Cust Switches are connected to dot1q-tunnel tu...
