Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I am replacing an ASA with an FTD managed by FMC at the main site. I have some FTDs , at remote sites, managed through FDM and the rest through FMC. I was able to setup S2S tunnel using dvti to all the FTD managed through FMC and was able t...
Hello Everyone,I am preparing for my ISE exam and having some difficulties getting Guest portal to work on the wireless using a vWLC running ver 8.10.151 and a physical access point (9115X) in FlexConnect mode. the Guest portal redirection works fine...
Hello, I have an FTD managed through FDM. I have two S2S VPNs using VTI and would like to do some path selection. I created two route-maps each matching a specific prefix list and each has BGP weight and local preference. I see that there is an optio...
Hello All, I have two cisco 9200 switches connected back to back. the two switches were connected through an ether channel (2 ports on each switch) in active mode. We lost power to both switches and all the ports in the ether channel went into suspen...
Hello ALL, I have ewc running on AP91915AX and was able to add other 9115X AP, but not the 3802AP. I upgraded the 3802 to version 8.10.121. I am receiving a version mismatch in the logs. I am not sure how to upgrade the 3802 to Version 17. Was anyone...
Hi Rob and thanks for your response,When we got these FTDs 5 years ago, I never felt comfortable plugging the management interface into public internet. I opted for FDM management as these sites were connected through S2S vpn. I may start bringing so...
If the computer is running Windows 10, why not use TEAP and use both machine and user authentication. If the machine is not part of the AD, it will fail authentication.
I am seeing the same issue with Windows 10 and TEAP. If I log in locally, both machine and user authentication are sent, However, If I do RDP, only machine authentication is being processed. The PC does not authenticate the user. short of deploying N...
Thanks Marvin.I have already created two route-maps and set the weight on each one. I am just not sure how to apply these routes maps so the FTD prefers a path over another for certain subnets defined in the route maps.
