After performing a "yum update" on the guestshell of a Nexus 9300 (9.2.(3)) I get prompted for a password when I try to do a chvrf. It doesn't take the switches password for admin. [admin@guestshell ~]$ sudo chvrf managementsudo: Account or passwo...
I am running a TcL script on a Nexus 7k and would like to suppress the output from cli commands. The TcL book says it can be done by enteringt "log_user 0", which works on a ASR router but not the Nexus switch.Any suggestions would be appreciated.
I need a url match in a CSS (v7.20) content rule to distinguish between these two urls:/sieb_poc/finsobjmgr_enu/!1.b78/sieb_poc/finsobjmgr_enu/!2.b78The command url "/*!1." is not valid.It appears that a letter has to follow the *Is there another way...
I got this when doing an upgrade on a CSM in a hybrid 6500:Any ideas? CSM> upgrade slot0: c6slb-apc.3-2-3.binUpgrading System Image 1CSM ExImage Tue Jul 06 11:18:07 2004Checksum failed; G:cfe4d449 C:cfa4d449ting:session.rom......R|W| Reading:lam_ppc...
Thanks for the reply. I found that if I create a password (in the guestshell) for the admin account right after I create the guestshell, then I don't have any issues after the yum update. Are there any downsides with this approach? Would I still ne...
My problem turned out to be a VPC+ issue that occurred after a link to a FEX module flapped
Error message:
%FWM-2-STM_LOOP_DETECT: Loops detected in the network for mac 0015.c5eb.1742 among ports gpc1:302 and gpc1:1301 vlan 148 - Disabling dynamic...
