Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have convert my AIR-CAP to Autonomous
Cisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JD, RELEASE SOFTWARE (fc3)
but when all of step i get stuck with this, but no warning or error
i cant config and i have wait for 15 minutes and...
I have problem TCAM on my Router, Hardware CEF entry usage is at 95% capacity for IPv4 unicast protocol,i use both IPv4 and IPv6, so i cannot customize the use of Route.what memory should i upgrade if i want to increase TCAM ? MSFC ? should i upgrade...
Hello,
I have router that use WS-SUP32-GE-3B,
I have error after upgrade my IOS :
%MLSCEF-SP-4-FIB_EXCEPTION_THRESHOLD: Hardware CEF entry usage is at
95% capacity for IPv4 unicast protocol
#sh mls cef summary
Total routes: ...
I have update my Cisco Switch OS to c3560e-ipbasek9-mz.150-2.SE6.bin,but after reload this switch, this switch booting and only show look like this picture.I wait until 20 minutes but not change.
I have set baud rate 9600 and try another baud rate but not work,I have install that switch and running properly two weeks ago, I think this problem not about console .
