Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have the c3kx-nm10g module in a 3750 and are tying to use Cisco 10g-SFP-AOC3M Twinex cables, but the transceivers are not being recognied.. any ideas?
Hi all, I understand that well known ports (0 - 1023) are reserved for well known or common services (such as http, smtp, etc) and I also understand that Ephemeral ports are short lived dynamic assignements typically used for specifying a source port...
Whenever we run an FTP job that has to pass through 2x ASAs the connection is extremely slow (lots of dups). Job runs fine when only running through one. Both ASAs are running 9.2. Any thoughts or pointers?
Hi there, I have a couple of questions regarding Reset-I and Reset-O messages on the Cisco ASA. I read a document that Reset-I will appear on the ASA if the inside host resets the connection, but what denotes an 'Inside' host? Is the inside host de...
bits are either enabled or disabled, i.e. 1 or 0.. my question was is there a term to describe the value assigned to each bit. i.e. one bit when enabled has a value of 128, when another may have 64128 64 32 16 8 4 2 1 0 0 0 0 0 0 0 0
yes you can but the problem is this:To require a username and password for the serial interface (console) of the ASA you have to issue the 'aaa authentication serial console LOCAL' command in the admin context (as it doesnt not exist in the sys exec ...
okay, so I have found that you can secure the appliance console access by using AAA from the admin context, however if you do this it uses the local userames stored within admin and not those created in sys exec space.
