Hi everyone I have a problem with the DHCP server. I created a DHCP server in the Catalyst 9400 for a VoIP Vlan.
Everything works, but when I restart the phone, it takes a new address.Why ?
I attach the DHCP configuration:
!
ip dhcp excluded-address ...
Hello expertsI have a problem with an MPLS adjacency.I have an ASR900 connected to a 10Gb C9300, MPLS and OSPF are enabled in this interface, adjacencies are created and everything works.When the C9300 is restarted, the MPLS and OSPF adjacencies are ...
HI
I have a problem with C6800.
I configured the DHCP service but the vrf VRF-A command does not exist?
ip dhcp excluded-address 10.xx.xx.1
ip dhcp pool VoIP_UC14_V254
network 10.xx.xx.0 255.255.255.0
default-router 10.xx.xx.1
option 150 ...
Thanks all for support, below the output first the C9300 reload:
OSPF:
interface TenGigabitEthernet0/1/7
description Link to TEST
mtu 9198
ip address 10.86.186.253 255.255.255.252
ip ospf network point-to-point
ip ospf 1000 area 0
cdp enable
...
The ospf process does not go up because there is no mpls adjacency.
The loopback was inserted into the ospf process, as I said, before the reboot of the c9300 all ospf and mpls worked.
After the reboot nothing goes up anymore.
