Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Some information on BE5000 and BE6000 : •Business Edition 5000 runs on a single hardware platform (MCS 7828), and it provides a single instance of Unified CM (a combined publisher and single subscriber instance). A secondary subscriber instance is no...
UC Voice Application Connectivity in a VMware UCS Environment
Table of Contents Introduction Troubleshoot
Introduction
This document describes how to troubleshoot connectivity issues when Cisco Unified Communications Manag...
IntroductionThe address resolution protocol (arp) is a protocol used by the Internet Protocol (IP) [RFC826], specifically IPv4, to map IP network addresses to the hardware addresses used by a data link protocol. The protocol operates below the networ...
Is the issue specific to the RP which has FAC/CMC ? Try to create a test RP without CMC and use it.
Does the call reach the GW or fails at the CUCM itself ?
If you are trying to monitor what the is happening on the MCS server, you need to connect the server to a monitor using the console cable, not to the PC.On the monitor you will be able to view the BOOT process after powering on. Please clarify the qu...
We can use the Single Number reach feature on the call manager to archive this, below is for reference :http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/9x/uc9x/mobilapp.html#wp1237920 We need to configure the remove destination (ie the m...
Did you make sure that the extension mobility is enabled on the phone configuration page ?What happens when you try accessing the EM service from the phone ? is there any error message displayed ? -Rohit
