About sextrand

sextrand · 10-18-2004

I have a 2620xm router in Mexico with a VWIC-1MFT-E1 terminating an international E1/T1 circuit. The telco DACS drops E1 channels 25-30 at the border crossing to the US, terminating on another 2620XM in the US with a VWIC-1MFT-T1. I have used this c...

sextrand · 12-03-2008

A seed device is where Cisco Works begins learning about your network topology. A core switch or router is generally a good seed.

sextrand · 10-19-2004

I stand corrected on the 3640 capabilities. Wouldn't a loopback address serve as a better anchor point for the VOIP dial peer than any physical interface?

sextrand · 10-18-2004

I had a similar problem between a 3745 in Mexico and a 2600 in the US. Turned out the issue was missing network-clock-participate commands on the 3745. We were using an AIM module on the 3745, but I believe the command is needed when using a NM-HDV ...

sextrand · 08-05-2004

Like so many design questions, the actual answer to yours is "it depends", but a few things cross my mind.Given a hub/spoke environement, what you are needing is uplink port aggregation. With your stated goal of 1GB uplinks, a 2950 is not going to pr...

sextrand · 08-04-2003

It's almost certainly your modem. We ran into the same problem. Modems we used for OOB access to older 2500, 4000 and 7000 series routers caused the newer 2600, 3600, and 3700 series to go into ROMMON.We did extensive testing using a serial protoco...

Member Since	‎04-09-2002 09:19 AM
Date Last Visited	‎04-27-2021 04:12 AM
Posts	8

User Statistics

User Activity

E1/T1 with E1 VWIC

Re: Seed Device - Campus Manager

Re: One way voice transmission issues

Re: One way voice transmission issues

Re: Large Enterprise Switch vs. Several Smaller Switches

Re: ROMMON - Booting into