Hello, We have two 3560G-TS-E running 12.2(35)se2, configured as HSRP. Both are running ntp config "ntp peer 210.72.145.44" and it's pretty well that they get the correct time. Yesterday I upgraded the second device to IOS 12.2(58)se2 and ntp doe...
Hello, I'm trying to implement QoS on our guest vlan, to limit vlan bandwith to 1Mbps. I'm reading the cisco config guide about QoS. It says that "Policing uses a token-bucket algorithm." There is syntax "police rate-bps burst-byte [...
Hello, I understands cisco 1262n can support up to six antenna. The supplier suggests three 2.4G AIR-ANT2422DG-R antenna and three 5G AIR-ANT5135DG-R antenna for one AP. I'm wondering whether this AP needs all six antenna so it can work? or how m...
Hello, I have one 3560 Layer 3 switch. I want to limit one vlan bandwidth to about 1Mbps. So I configure rate-limit as below:rate-limit input 800000 100000 200000 conform-action transmit exceed-action droprate-limit output 800000 100000 200000 co...
Default asa setting disallows ping from internal world to outside world.you said "Cisco_3560g (g0/24) ---> (e0/3) Cisco_ASA_5510 ---> Cisco_2811 ---> Interweb"and then "Just too make sure of the above, I connected a PC (IP 192.168.1.5/24) to g0/24 an...
Hello, Since this is a hot-standby device, I reloaded it. But many 10 minutes passed, the time is still not sync. The only difference is IOS upgrade. What else could be missing?
