Ok, I'm sure there's documentation on this *somewhere*; but I haven't been able to find it. I'm somewhat new at "Cisco-ese". I have a Cisco 5548 switch. It's running an old release of NX-OS (5). I want to upgrade it to the latest supported; which...
Ran into an interesting problem with a WAP4410N that I haven't used for a while. I couldn't remember the password I'd originally given it; so I reset it to factory defaults. When it rebooted; it picked up an IP address (wired side) from the WRVS4400...
And it *does*. Interesting. It appears one can do things via ssh that the web gui won't allow. Too bad as far as I can see there's no actual *documentation* on configuring one of these units via ssh vs web. On another note; on my WRVS4400N one can'...
Some interesting additional data: I had enabled ssh access prior to changing the IP mode/address. The new password for the admin account *worked* with ssh. Invoking "get password" showed the correct password. Doing a "set password" to the *same* ...
