Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys,
Is it possible to apply dscp marking based on destination IP?
My understanding is this, it is possible by creating an extended access list and then apply a route map out of the interface I want to send the traffic from. but this takes us to...
I have a default route already configured manually in my routing table, let's say that I have a new BGP connectivity and they start advertising default route instead of whole vrf routes. what would be the behaviour of routing now that I have 2 defaul...
Hi Guys,Anybody has a link or a document for the latest/current cisco routers and switches series and models with specifications and recommendations of when to use each one? I find some documents but all are old and not updated with the new routers/s...
Hi Guys,My understanding of stacking is that you you have up to 8 switches stacked together where there can be treated as one switch but at the same time you can utilize the ports for all of the switches.... is that right ? also is there other benefi...
Hi Guys,Can you explain what is the different of having the multiple RRs using the same Cluster ID vs. using different cluster IDs?What is the benefits of both designs? which design is preferred and why? Thanks,
Yes,I am thinking to configure an HSRP for the WAN side, sot hat if R1 goes down, only changing the physical link and plug it to R2 would shift the traffic.
Yes, both routers have LAN connection configured with HSRP for Up link traffic. However, for Down link traffic, only one physical link is available. Hence i was thinking to configure HSRP to avoid doing any configuration if router 1 goes down.
I just found this cisco document for a general L3 Interface Configuration:http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/15-0SY/configuration/guide/15_0_sy_swcg/layer3.htmlAnd the document mentions that:"The VLAN IDs used for Laye...
