Hello all, I configuring vtp on my switch and i can't receive Vlans from my Vtp Server.I receive this error:%not enough space on flash to store vlan database even after squeeze I clear my flash somtimes and this action not resolv problèm. Please Hel...
Hi all, i've ridden à OSPF network with EIGRP redistribution. in my eirgp area, all work fine, but is not the case in my OSPF area although all configuration are OK. I receive this message: Mar 1 01:59:14.015: %OSPF-4-BADLSATYPE: Invalid lsa: Ba...
I have a router 7500 serie and he start on boot mode only "router(boot)>" i can't any interface, and i put the confreg to 0x2102, but i don't have change. please help my is very urgent
Hello Rustynono I anderstand you problem but all i can say to you is that, when de router A and B exchange their DBD, they must respect many conditions like, the Size of Packet exhanged (MTU) that depend of the size of Routing table of every router,N...
Hello my friend Wtih this access-list, you can't cover adress 10.1.1.8, but you in you access-list, you cant add this command: ip extended access-list traders20 permit ip 10.1.1.8 0.0.0.0 any (or 20 permit host 10.1.1.8 any) this command will pre...
Hi, If your modem has one ethernet or Fastethernet port, you can connect it directly on you f0/0 and connect you switch on f0/1 port, secondly, give those IP addresse, and activate routage. Exemple:Router(config) int f0/0Router(config-if)ip address...
