Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts!
I'm currently using three 3595 ISEs.
I want to add another 3615 here as a PSN.
Currently information
ISE1 : PAN(Primary) + MNT(Secondary) + PSN
ISE2 : PAN(Secondary) + MNT (Primary) + PSN
ISE3 : PSN (Health-Check node)
Is there p...
Dear all,
Currently in use AP-1131AG lightweight mode in WISM-1.
There are plans to change the WISM-1 with CT8510.
But I can not find support the AP1131AG in the CT8510.
I want an answer to this problem.
Thanks, all.
Hi All. Last week, I Configured LAG on CT2504 using following configuration: ## CT2504 (8.0.110.0)GUI access, controller -> LAG mode enable and reboot ## C4503 (with SUP7L-E, IOS-XE Version 03.04.02.SG) interface Port-channel1 switchport switchport m...
Hi, all. I used Static NAT in cisco 2811.But, 2811 Router is not have ARP in ARP table Topology isInternet - Router - Backbone switch - L2 switch - Cisco 2811 Router (this router problem)For example, currently in use the next table192.168.0.100 -> 1....
Hi all. I want create to virtual phone number on CME.For example, inbound call number is 6000. (This number don't have physical ip phone. Representative number)If, Can I used call-forward to another phone number? And, If it can use, Please give me CM...
Thank you everyone! I think my explanation is a bit lacking. This is the composition I want to use.ISE1: PAN + MNT + PSNISE2: PAN + MNT + PSNISE3: PSN (Health check node)ISE4 (New 3615): PSN The bottom line is that although this configuration is not ...
I can not test with different switch.I was tested disable Port-Channel and Gi2/5 shutdown. But, same issue. DHCP Snooping Config on 4503, Is it not issue?User is used static IP. Thanks your reply.
Thanks for your reply. Based on your reply, I create config for sample. Verify please. voice translation-rule 2rule 2 /^6000$/ /60../ Inbound call 01-2345-6000 (Representative number),6000 -> 60xx number. Is this config correct? Thank you.
