Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hey guys, testing my network using IPSLA but its strange how when i connect a router to the network and input the IPSLA commands it says it fails everytime? Im a student doing my project btw and am unsure why its not sending through the network. I ha...
Hey guys, so i have HSRP configured on two routers and its working just fine, the thing is the two routers are connected to a switch and i have two pcs connected (Pcs running PBX) to the switch. I want to configure NAT portforwarding so that when the...
Hey guys i have been stuck for awhile on trying to redistribute Vlans through OSPF. Ive struggled for awhile now and im still confused. Could i upload my packet tracer file and if possible could you point out where im going wrong? I have added the vl...
Thank you for your reply, i read up and have it all working now! The problem was in the Receiver not being able to connect past its gateway. Thanks again!
I needed it for the PBX to connect to. Its very long to explain but its ok! Thank you for your reply, i tried the Nat with hsrp and it didnt work :S but its fine, im moving on to the next step haha
i have placed the PC ip addresses in the same subnet as the routers gateway havent i? the PCip = 172.16.10.1Subnet = 255.255.255.240Gateway - 172.16.10.10 Router fa0/0 (gateway for PC)ip = 172.16.10.10subnet = 255.255.255.240 Is this correct? and i ...
thank you for replying again! So when you say make the router interfaces "known" to OSPF is that by the network x.x.x.x 0.0.0x area x command? i have trunked the interfaces to the routers and have setup all the subinterfaces, i just am confused as t...
All i want is the pcs on either side to have connectivity with different vlans configured for each one, i guess i believe it to be able to see the tagged traffic, detag it, then send it on its way, retag it and then send it to its destination... Is t...
