Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. Currently on an entire LAN VLAN1 is the only vlan configured among SG300's in a hub and spoke topology. I'm trying to setup a trunk between a 3560 switch to the "hub" SG300 to pass data over vlan 1. I've tried the below SG300:int gi14switch...
Hi all. I have two ISR4321 routers connected and have end to end communication at least from the L3 interfaces of each router (RTR1 and RTR2) to any device on the rest of the network. Granted I've only tested with icmp. Nonetheless, broadcast does...
Hi all. For a couple of years I've had two Cisco 1941 routers running IOS and BVI interfaces to support some end user devices. I have two Cisco ISR4321 running IOS-XE which from what I've read you must do BDI interfaces. I attached a diagram and appl...
Hi All. Is it possible to configure individual APs that are joined to a controller for settings such as login banner, username/password, syslog, ssh, ntp, and snmp? Or do the APs essentially take on the configuration of the controller once they joi...
Hello All. I'm trying to see what the logging buffer size is for a WLC running code 8.3.140. In the GUI it shows the syslog level is: Informational and the Buffered Log Level is: Notifications. If I use the command show logging, it shows me the fo...
BB, Hello. I tried the changes and still no luck. The spanning-tree states remained the same. I'm not at all familiar with Cisco's small business switches, but here are a few more things I noticed while trying different configs. 1. On the 3560 I crea...
BB,Hello. I tried the switchport mode trunk on the SG300 and still no joy. I attached the relevant config of the 3560 and SG300. There's also some spanning-tree output in there. I noticed despite VLAN 1 being Up/Up on the 3560, the 3560 sees itse...
BB,Hello. When I go to int gi14 there isn't any command option available to set the encapsulation. I just get:accesscustomerdefault-vlanforbiddengeneralmodeprivate-vlanprotected-porttrunk If I go further with either trunk or mode, there still isn't...
I created this post because I had ran into an issue based on one project that I initially posted about. Below is the other post which has the solution. https://community.cisco.com/t5/routing/ios-xe-bridge-domain-and-broadcasts/m-p/3929817#M322220
I figured out how to get the ISRs with IOS-XE working using BDI instead of BVI. Aside from the config, on RTR2-4321 I had to connect Gi0/1/0 of the switch module to the built-in Gi0/0/0 for the end user device to be able to access LAN resources a...
