About HassanTofaha

HassanTofaha · 04-21-2021

Hello my dears,the situation is we have the following:Cisco ISE , CUCM Cluster, Cisco IP phone, Cisco DX80our target is to make the IP phones & DXs authenticate using DO1X not MAB (on ISE).already installed the LSC certificate by the CUCM to all IP P...

HassanTofaha · 02-12-2020

thank you very match, that helped me, i was having the same issue and your solution helped me.thanks again.

HassanTofaha · 04-20-2019

Cisco offers another method of scaling link bandwidth by aggregating, or bundling,parallel links, termed the EtherChannel technology. Two to eight links of either FastEthernet (FE), Gigabit Ethernet (GE), or 10-Gigabit Ethernet (10GE) can be bundled ...

HassanTofaha · 02-28-2018

thanks it is working. # and after the mute microphone light release the # and in sequence press 123456789*0# wait a minuet and it will be factory reset and will boot normally .

HassanTofaha · 11-27-2016

You should make sure of the configuration of inter-vlan routing

HassanTofaha · 04-26-2016

this worked for me thanks alot

Member Since	‎05-04-2014 08:07 AM
Date Last Visited	‎04-23-2021 07:11 AM
Posts	13

User Statistics

User Activity

Enable 802.1x on Cisco DX80 to authenticated with ISE

Re: How did your FXO port

Re: Bandwidth/Throughput & EtherChannels

Re: Cisco 7841 phone Factory Reset using the Keypad

You should make sure of the

this worked for me thanks