Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We had an issue today at one of the unmanned locations. When the local tech went on site he was not able to reach anything on the internet. I started troubleshooting and noticed no entries in the xlate table. The NAT statements were all correct...
Hello,we are having issues with several Surface Pro 3 device connecting to a standalone Aironet. Other Device connect to this AP no problem. SP3 connect to other APs (not cisco) no problem. So there seems to be an issue between the two devices. When ...
Hello,So I have a new project upgrading our old 5510 over here to 5515x. 5510 is running 8.2 and 5515x will run 9.x From what I have read I won't be able to easily just copy running config and slap it on a new 5515x. Does anybody know whether Cisco i...
Hello,I have just purchased a Cisco 891-k9. I have purchased it to learn how to configure site to site VPNs. Below are my "sh version" and "sh license". Can somebody explain to me whether I have the ability to set up VPN. Also, if somebody can point ...
I read that lan base ios doesn't run on 2960s switches, my is Catalyst 2960-24-S. Is there a way to run base insead of lite on 2960s? Perhaps there is a base lan image out there that will take on 2960-24-S? Please advise.
I just went through this with TAC. To properly upgrade to the latest version if you are coming from 03.xx.xx release, you must include "new" and "force" optional arguments in your software install command. software install file flash:cat3k_caa-univer...
Well we know exactly what I added...Its in the body of my original post...Obviously I can't remove those commands now and add them line by line because that would break internet for the site...I already read through the link you mentioned. There is n...
Latest update from October. Issue has been resolved. Combination of WPA and AES worked. I guess SP3 has problem deciding which cipher to use when both AES and TKIP is enabled on the AP. Now, I hope that other devices will be able to connect...
