Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All.I have this error by aACI Simulator 13:00:16 Environment Driver Setup has begunBeginning sandbox setupPreparing connectivityApps deployment started Apps are being discovered...Connecting all apps<font color="red">Error occurred during "Connect...
Hello All. Is there the best practice for securing access to ipv6 network on the internet edge routers?
Like for ipv4 below and i want make up something like that for ipv6.
access-list 100 deny ip 10.0.0.0 0.255.255.255 any
access-list 100 deny ip 12...
Hello everyone. I have an issue with my Nexus 9k. After server connected to pair of N9K is reloaded, traffic in one of LACP port-channel link doesn't flow. As a result of this partly looses traffic. On Nexus and server ports are up. No error message...
Hello, i have vpn configured on ASA, but it doesn't work properly. Connection between 10.71.29.0 and network other than 10.19.180.56 works fine, but ASA doesn't encrypted traffic from network 10.19.180.56/29, but i see this traffic on capture. I have...
I have reserved another ACI LAB and run into the same issue: 18:00:19 Environment Driver Setup has begunBeginning sandbox setupPreparing connectivityApps deployment started Apps are being discovered...Connecting all apps<font color="red">Error occurr...
You can use and advertise both prefixes
"each one for each router" doesn't make any sense
Probably you got confused with interface addresses for each router
Hello, thank you for answer. I've decided the same too. Traffic counters on the Nexus's side were inbound and outbound, but on the server's side was only outbound. I think both nexus and server negotiate port-channel but server doesn't move this port...
