Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, experts.
My customer want to get the SNMP GET results about the traffic rates in the specific ethernet interface like ethernet 1/31 and 1/32 from the Nexus device
ex)
30 seconds input rate 3112 bits/sec, 1 packets/sec
30 seconds output rat...
Hello, Experts,
My customer want to know the power consumption and lbs of the UCS Blade and Modular series.
So I could find the information about it with the tool "UCS Power Calculator".
But they also want to know the heating value of the syste...
Hello, Experts,My customer want to know the power consumption and lbs of the UCS Blade and Modular series.So I could find the information about it with the tool "UCS Power Calculator".But they also want to know the heating value of the systems but I ...
Hello, Experts,
My Customer has port down problem with UDLD mismatch which was caused by peer nexus switch.
The peer nexus switch is sending UDLD packet with its own Chassis ID (S/N)
But the switch which has the issue is shutting down the port when ...
Hi Experts.My customer is using EIGRP and they also use VRF in address-family in IOS-XE (4500-X) like below.router eigrp 65200address-family ipv4 vrf VRF1 autonomous-system 1address-family ipv4 vrf VRF2 autonomous-system 1Question is, Could it be pos...
Thank you for your support, Inayath.
Customer is trying to find cable mismatch but it should spent more time since their DataCenter is not manned site.
Customer has no UDLD config but feature config on both ends. I think I should investigate the docu...
Thank you for your help.
CSE has been tested in their lab with the configuration disparity but it was not reproduced.
So, my customer will test the config in their maintanence domain.
Thank you for your fast reply and it was late that I could receive the logs from my customer.
When I lookup the log, I could find that there is no udld configuration but "feature udld" on the switch.
Could it be a clue for this case? and also I could...
I cannot get any screenshot since it could viloate customer’s security policy. My phone cam has been sealed and extracting screenshot from labtop was prohibited. And I can see the both LUNs (target’s PWWN) when I click F6 on boot
