Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have two peers configured as follows (I'm only including the config of the RR client, but the RR config is analogous): RP/0/0/CPU0:PE4#show run router bgp 65000router bgp 65000 address-family ipv4 unicast additional-paths receive additiona...
Hello,I have been recently struggling with several filesystem issues, I've tried several DSCs and have different problems on each. I'll focus on the most recent ones.(Issue #1)My disk1: went nuts after I aborted a stuck upgrade operation.It doesn't s...
Hello,In Junos, a BGP Route Reflector can reflect vpnv4 routes successfully even if it doesn't have MPLS reachability to the PEs. Simply with this command:set routing-options rib inet.3 routing-options static route 0/0 discardThis installs a default ...
This config did the trick:router bgp 65001vrf VRF-Caddress-family ipv4 unicastnetwork 0.0.0.0/0 However, this other config did not do the trick:allow vpn default-originate Comments welcome.
Hello, Would you mind telling me if this other RP is affected by the same limitation? Sorry I'm far from being a CRS expert. Thanks! CARD 0/RP0/* : Cisco CRS-1 Series 8 Slots Route Processor MAIN: board type 100002 800-22921-17 rev F0 ...
Hello,Junos has been adapted to accept Max PDU value of 1000.This fix (via PR/1007096) will be available in 14.1R3 and 14.2R1, currently planned for early October.Hope this helps.Thanks,Ato
