Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2921 running IOS 15.2(4)M6a and I have the problem descibed in bug CSCtl79911. External SCCP calls coming into the router from a remote 2821 through an IPSEC tunnel will connect to the called phone and I can carry on a coversation if I answ...
I have run into an odd behavior with my 2811 router. The router is booting into ROMMON.I was able to get the IOS back up and running with the tftpdnld -r command. I checked the CF card and it was corrupt. The CF card is a Cisco branded 1GB card that ...
I have two 2821s running IOS 15.1(4)M8. I have a remote CME with 13 phones registered to it. I have a local CME with 3 phones registered to it and a NM/CUE module. Two sites are connected using an IPSEC-L2L tunnel through the internet. The CUE can pi...
I have two Cisco 2821 gateways connected through a site-to-site VPN. Gateway A has a dial-peer to allow calls to extensions on Gateway B.
Gateway A Dial Peer:
dial-peer voice 1000 voip
destination-pattern 10..
session target ipv4:192.168.15.3
Gatew...
My network setup:
I have a 1760 behind a PIX515e which has a site-to-site VPN connection to an ASA5520 which has a 2821 behind it. The 2821 has a Voicemal Service Engine.
The 1760 is running CME 4.1. The subnet for this networ is 192.168.15.0
The 2...
I finally solved this. Thanks to everyone who supplied comments. Forgive me if I am giving away any GURU secrets, but here's what worked for me.... I bought serval different kinds of CF cards, including some (ridiculously expensive) CISCO branded CF ...
