Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Sirs
I install a wlc 5520.
And setup Management Interface(EXP:192.168.1.1) and Ethernet service port (SP) (EXP:192.168.2.1)
I can connect and management Ethernet service port (SP) (EXP:192.168.2.1) with Browser and SSH.
But i can't connect Mana...
Dears
I have Cisco AMP 8150(5.4.0.1) + Virtual Firepower Management Center Data(5.4.0-763)
When I apply to device,and complete. my syslog server success received log.
But short time,mybe 1min,10min,30min...my syslog server not received log.
untill I ...
HI
I have 6807,it's standalone.
Version 15.2(1)SY1,bootdisk:s2t54-ipservicesk9_npe-mz.SPA.152-1.SY1.bin
VS-SUP2T-10G*2,C6800-32P10G*2
Soon,i have another same 6807(VS-SUP2T-10G*2,C6800-32P10G*2).
i will use line card(C6800-32P10G) 10g port to build...
HiHow can i change IPS nodule software versionExample:6.0(6)E4 change to 6.1(1)E2By the wayIf i have two asa 5520,and they are HAthe two IPS module have need to same software version?Thank you for your help!
Hello,I have a problem with VSS in the 6500, when the switch 1 is active,probably a few months will switchover to switch 2 and switch 1 reload.config:switch virtual domain 1 switch mode virtual switch 1 priority 110 switch 2 priority 110interface Por...
Hi
But I have C6800-32P10G
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6800/hardware/installation/guide/b_c6800_modules/b_c6800_modules_chapter_01.html
This document say "With Supervisor Engine 2T-10GE —Cisco IOS Release 15.2(1)SY or ...
Thank you for providing the requested information.But my question is why the switch 1 switchover and then reload.Is it possible this problem related to VSL link?
