Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have two trusted certificate in both expressway. One certificate is expired and jabber stopped working. But we have one valid as well. If i delete expired certificate then it could start working over MRA. Any idea? Thanks
Hi Everyone, Do we need to get a support contract for below part numbers? We are not performing any upgradation. Thanks LIC-UWL-STD-AServices Mapping SKU, Under 1K UWL STD usersUPG-CUCM-BASIC-AUpgrade to UC Manager BasicMIG-VCS-UCM-ENHMigrate 1 desk...
Hello Community members,
We are planning to replace Fortigate 100D with Cisco ASA 5510. Is it worth replacing? Any suggestions? pros and cons?
Really appreciate. Thanks mates.
Hi folks,
I need to get some help. I have one public subnet and one of the static IP i am using to nat inside.
Since i dont have FW so i want to restrict some ports on same IP but i dont know the best approach.
Network: 77.123.45.16/248
Gateway...
We aren't purchasing any new CUCM licenses. Moreover, we had got SWSS before and now it is going to expire soon. it's incomplete and this is few SWSS license and its a big list.
Thanks Georg for your efforts.
Can you please clear my doubts.
1) ip nat inside source static 10.100.208.74 25 77.123.45.19 extendable
Does above command do natting from outside to inside and then inside to outside?
2) If any traffic comes from ...
would it be applied "in" or "out". I have already one ACL on WAN interface and direction is "in" to deny some protcols.
Main target is to allow only port 25/443 on 10.100.208.74 which is natted 77.123.45.19
When i give command as you suggested like
i...
we want to nat inside with all ports but after that when traffic comes to local interface then implement ACL.
Like for example, in one scenario i have nat as below
ip nat inside source static 10.100.208.74 77.123.45.19 extendable
then at FW level o...
