Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
We have a CME router Cisco 2951. We bought another one to act as backup. I've copied most of the config from Primary CME to Backup CME. For some reason I can't create interface VLAN(SVI) on the Backup CME. They have similar iOS and hardware (exce...
We have 3750 switches and recently we had an issue with cable wasn't plugged in properly. It was hard to see it as it's got a lot of small pins.I would like to monitor the status of the stacking port. We have appication (Nable) which use SNMP to moni...
It was puzzling for me and I wasn't sure if it's needed but had some issues when connecting backup CME.
Now I rebuild it and it's working fine.
Thank you for your support.
Regards
Hi Mark
Primary CME
CMEGW-01#show vlan% Ambiguous command: "show vlan"CMEGW-01#show ver | i 295Cisco IOS Software, C2951 Software (C2951-UNIVERSALK9-M), Version 15.5(3)M3, RELEASE SOFTWARE (fc2)System image file is "flash:c2951-universalk9-mz.SPA.1...
Hi Mark
On the primary CME there is
interface Vlan1 description $ES_LAN$ no ip address
I can't create one on secondary although it have almost the same iOS and hardware so am I missing something?
Hi Hector
Thank you for checking the config.
I'm confused as the Primary CME has got ISM with SRE module which was used for Voicemail but we don't need it as backup.
The module shouldn't provide the switch capability for the routers so not sure what...
