Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,If two 7609 are connected through layer 3 giga etherchannel and 7609-1 sends a frame with 1514 bytes plus two MPLS header to 7609-2, does the command “mpls mtu 1522” under the giga etherchannel interface on both routers is enough? Or it is ...
Is there a reason to configure "dialer load-threshold..." on both local and remote router?I configured it both ways and it seems to work without problem.What would say the best design practices?
Hi Rick,Yes, that is my point. I was trying to help the originator. He is asking if that would be possible (deny during NCP negotiation). I don't think so.
If I am not mistaken, you can see what protocols can be permitted on the isdn with "dialer-list 1 protocol ?"For example, CDP can not be permitted, so it will not bring up the link.dialer-list defines what will bring up the link.after that, any pack...
