592
Views
0
Helpful
1
Replies
Implementing MPLS into a Traditional ATM Network
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-04-2003 10:37 AM
Is it possible to enable MPLS in a LS1010 interface that already has PVC configured?
Labels:
- Labels:
-
MPLS
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-10-2003 11:44 PM
Hi,
I didn't use LS1010 before and don't know the answer of your question. But basically I can say that any ATM swith is NOT a MPLS enabled ATM switch. An ATM switch must run IP protocol to operate as an MPLS enabled ATM swicht. Pure ATM swicthes can't do it. On the cell mode operation ATM switch builds a control PVC (default 0/32) and over this PVC it creates LDP session to other equipment. So the software should also support this type of operation.
Regards
