Hi All
I have been given requirements by out it staff that they need to configure a server with a public IP address , This would not have a NAT , Can any one explain if its possible to protect this server behind our firewall ? As this will be on t...
Hi Folks
I have a strange issue with my HOTSPOT redirect.
When user logs in they are presented with the access page , enters the correct code. The page attempts to redirect to the home page I have configured but it loops back around to the connect...
Hi All .
I am new to ISE 2.3 , I am looking for a way to
1. Authenticate AD users onto wireless BUT if the user is NOT in AD allow the PC in by creating a by pass using its MAC
I would like a simple policy to allow this .
Any assistance wou...
Hi All
Is there any way I could set up and SSID on Cisco WLC that will authenticate using both 802.1x dor AD users AND authenticate other devices via their MAC Address ?
My other option would be to create 2 SSID , one for 802.1X and AD users , an...
Evening All,
I have a few questions regarding Wireless WLC and ISE , The best way to configure the following .
1. A guest network that can use a token to login and change every day,week etc. I see the token option on ISE but cannot find any do...
Hi Thanks for the input ,
But the public IP is already outside the firewall on the public facing Vlan ( same vlan as the outside interface of the firewall ) then its already in front as its not natted. So traffic would hit it directly ....I think
Ok, I disabled Mac Auth and this seems to work ,
However , I cannot seem to get my policies to work, Can anyone give me an example please ?
Where 1 SSID can :
1. Use 802.1x and authenticate both AD users and Non AD users ( Mac address ) ?
If pos...
Hi Jhosbell,
If I enable mac filtering I get the following on the WLC - Cannot enable MAC filtering and other Layer2 Security with Radius NAC.
Can you confirm what I need to configure on the WLC in order to allow the mac filtering , the ISE rule...
