Hi Folks
Does anyone have a working configuration for QinQ through EoMPLS on the 6880 platform? We can't seem to get the tagged frames through the EoMPLS VC. I have noticed this caveat in the documentation:
"802.1Q in 802.1Q over EoMPLS is supporte...
Hi, Please could someone give me some guidance on the input queuing model on the WS-C3560CG-8PC-S switches? It seems that Cisco have reduced the configurable SRR Queues from 2 to 1 for this particular model though there is no documentation at all fro...
Hi,I'm working through a QoS configuration for the 6880-X-LE with 6800Ia FEXs. The QoS configuration, policymap, classes, ACLS etc have all been accepted fine. I can apply a service policy to an interface but when I do I get the following errors come...
Hi all,Hope someone has seen this before.We recently started deploying interface based QoS configuration out to access switches. During the deployment to the first switches, 2 Cat 6500s, we encountered this issue GigabitEthernet1/24 Service-policy i...
Hi Shobith
I know this post was some time ago now, but I've just encountered the same issue. No fix, but have a workaround which is to increase the terminal length, e.g. 'terminal length 512'. At least lets you see the config!
David.
UPDATE: Se...
Hi Aninda, OK, we're just confused because we have applied a similar configuration to a 6500 (less the policing) which applies without issue. I've pasted it below, there are at least 12 match DSCP entries. Does the 6500 range have a difference limit?...
