Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,During planned electricity poweroff - we had a strange issue with 2x SG200-50P switches. After electricity come back - our switches booted properly, but some devices were not powered through PoE (mostly IPTV camera). So we've tried different po...
Hello,We own an Cisco SG350XG-24F switches (2 pcs, stacked together), which are connected to SG350-10 switch (owned by our ISP).1/XG24 and 2/XG24 (copper RJ45) ports from our SG350XG-24F are connected to the 1 and 2nd port of the SG350-10 switch. Bot...
Hello community,
I have 2 Catalysts 2960X stacked to each other. Few days ago our stack master failed, soon we'll getting a RMA replacement, but I have question about "best practices" when replacing failed stack member.
What are the steps to connect ...
Hello,We want to connect SG200 to Catalyst 2960X via optical fibre. Now on our SG200 (SG200-50P-K9-EU) switches are using D-Link DEM-311GT SFP modules.We found module Cisco GLC-SX-MMD, that is compatible with Catalyst series switches, but there's no ...
Hello,We have noticed, that our one SG200-50P is having problem with Internal MACReceive Errors on LAG interface. 2nd SG200-50P, which is on the other side of this LAG is without any errors.Previously we had FW 1.3.5.58 and some old bootcode, but we'...
As more and more switches had similar disease, we've just backed up the config on switches and made factory reset + backup restore. Working flawlessly.
Hello,Unfortunatelly SG200 doesn't have any console or SSH to manage it via CLI.But we've tried to shutdown PoE on specific port, and turn it on again - no luck for us, only factory reset helped...
Checked IOS release notes, and didn't found any console bug or fix for it.
I connected console cable 1st on master switch, then to slave, now on both switches console port stays active.
Thank you guys - new switch plugged in - everything works flawlessly, both answers were helpful for me.
But I have another question about console port - when I plugged a console (RJ45) cable on the new switch (and then the old switch - currently sta...
