Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I would like to mesh a 2602 AP to other 2602s on a 5508 WLC. This AP will be mounted to a vehicle and driven throughout the mine. I was wondering if it was possible to mesh this on multiple channels. I know that I can get AP to connect to acce...
I am unable to issue any 'mls cos' commands in global configuration or on a specific interface. I have never configured a IE4000 before and am attempting to configure it similarly to our IE3000s.Thank you in advance
Hi, When I plug in access points they will cause the port to go down on err-disable because of the BPDU Gaurd. 2602s never used to send BPDUs has this changed with the access points or something else in the system. Is there any need for the guard wh...
Hi, How does one refresh an APs DCA from the controller? I removed an interferer and all my APs on the corresponding map do not use that channel (channel 6). I have tried restarting all of the APs. Here is what the AP sees with show ap auto-rf 802.11...
The 7925g deployment guide recommends enabling beam-forming, I have 30 / 160 MIMO antennas and coverage is an issue. Are there any disadvantages to enabling this setting? Will it cause any problems on the APs attached to a single antenna? Will it ma...
We have RFID Tracking tags that only have a 2.4ghz radio. We are stuck with these. Additionally 70% of our area is covered with 1242 APs that are attached to a single 2.4ghz antenna. Would it be viable to only enable clientlink on 802.11a?
Thank you very much for your help. Is it possible to jolt the system to reassign channels? All my other APs on the map are on channel 1 and 11. Currently I am not sure if it hasn't done this operation because it doesn't need to, it still detects p...
