cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
5
Helpful
3
Replies
Highlighted

Refreshing DCA AP list.

Hi,

 

How does one refresh an APs DCA from the controller? I removed an interferer and all my APs on the corresponding map do not use that channel (channel 6). I have tried restarting all of the APs.

 

Here is what the AP sees with show ap auto-rf 802.11b 

  Nearby APs
    AP 00:3a:98:89:72:d0 slot 0..................  -71 dBm on   1 (10.48.193.252)
    AP 00:3a:98:94:f3:b0 slot 0..................  -74 dBm on   1 (10.48.193.252)
    AP 1c:de:a7:ee:71:90 slot 0..................  -84 dBm on   1 (10.48.193.252)
    AP 44:ad:d9:f0:50:40 slot 0..................  -94 dBm on   1 (10.48.193.252)

 

Any help would be appreciated

 

There may not be much of a data rate loss but my interband roams sometimes cause an interruption to VoIP service.

 

Thanks

3 REPLIES 3
Highlighted
Rising star

DCA is taken care by controller, it uses the algo. to dynamically assigning the channels. It uses the sw- decision metrics to come out with the results. 

Highlighted

Yes but it is doing it incorrectly because of an interferer that I removed.  How do I cause get it to reassign channels?

Highlighted

DCA run at intervals you configured (by default every 10 min) if you set it to Auto. If you want to invoke channel update once, you can select Freeze & Invoke channel update once option as shown below.

HTH

Rasika

**** Pls rate all useful responses ****

Content for Community-Ad