Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to set up a remote small office with an FTD in the coming days and have been informed that we will need two Public IPs. 1 for the outside interface & 1 for management interface. Is that a correct requirement for an FTD? Are there any kno...
All, I've loaded APs into a large area map. After adding APs and saving, occassionally after a few hours 1-3 of the APs will spontaneously move on the map, appearing to dissappear. When I search for their specific names, I'll notice their x y's...
How to recover and troubleshoot an AP that was changed to bridge mode and subsequently lost connection to the controller? Tried toggling switch ports to force reboot, however unsuccessful. Curious if there's a solution without having to manually ge...
All, I have something similar to this issue. Trying to make a 3602e with external antenna a root access point and I got the same error as noted above. However when I go to Wireless>Access Points>Radios>802.11a/n, there is no drop down option unde...
Hi Sandeep, Thank you for your response. The problem is that the AP's that were changed to bridge mode are no longer visible on the controller, and unresponsive to pings.
