Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I'm trying to fix this situation: Router P (provider) has to link, one to Router A (10G) and the other to Router B (1G). On both links there is an OSPF router 50 set up to publish routers from the providers to the internal routers. Router A a...
Hi guys, I'm just starting to configure a WLC 5508 for employee wifi access. I did the LDAP setup, configured a local PEAP profile etc.When I try to setup the wireless connection on my smartphone, I get a certificate warning about the self-signed Cis...
3 switches: A <--> B <--> C
all ports are configured as static trunks with only 2 allowed vlans (734 and 834)
VTP Version 3, all the switches have correct domain and password.
Switch B is a bit old, so has the 255 max vlan limit and my vlan database ...
Looking at the attached network diagram, when all links, routers and switches are up, R2 is the VLAN101 gateway and R3 is the VLAN102 gateway, but R1 chooses R2 as the destination for both routes.We use OSPF to redistribute loopback addresses and BGP...
Hi, I'm wondering why the sh standy output is different in the tracking section... any guess? Both switches are using 12.2(44)SE5 IOS. Node1track 1 interface Vlan301 line-protocolinterface Vlan301 ip address 10.10.253.253 255.255.255.0 ip helper-addr...
Sorry for the delay guys, and thanks for replying. The issue was related to the "order of events": when switch B did the redistribuition into BGP of the incriminated route before receiving it from router A, it discarded the latter. The solution was t...
I enabled vtp pruning on the server, like you suggested. No changes. I also pushed again switch B into client mode but the vlan manager is again reverting to transparent and sw. C still doesn't receive anything.
Best regards
