Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to ask your assistance for connecting a pair of UCS Fabric interconnect (UCS-FI-62) to switches in VSS mode.
I know Cisco Validated design includes connecting (UCS-FI-62) uplinks to Nexus switches only.
Can you point us to design or depl...
Hi Everyone, We are planning to deploy Cisco APs in our remote site. I believe we need to run them in Flexconnect mode however we are planning to deploy Cisco 3850 at remote sites and make them run as local Wireless Controller and all these switches...
I am using Cisco Aironet AIR-LAP1142N-E-K9 on my network and it's connected to Gigabitethernet port on my 3750 switch, but for some eason it's neotiating only 100Mbps all time even when I run speed auto from both sides. If I run 1000Mbps from the swi...
I am trying to Configure IP Accounting on my ISR4451-X/K9 WAN Router, but the command IP accounting isn't working. May I ask for assistance with this issue
You can deploy it just fine with vPC. You just have to enable port channel unconditionaly from the switch side meaning mode on. As for the other configuration your port channel has to be in single vPC if you are using pair of 5k in vPC mode. I have 2...
Thank you guys for the update. I have managed to configure the 3850 as MC but I have two things I would like to ask your assistance: 1) The switch is running version 03.7.0E and when the AP register to it they get IOS version 7.6. How can I upgrade t...
Please find below: BTaS-7F-SW-2#test cable-diagnostics tdr interface gi BTaS-7F-SW-2#test cable-diagnostics tdr interface gigabitEthernet 1/0/14 Link state may be affected during TDR test TDR test started on interface Gi1/0/14 A TDR test can take a f...
