Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It acts like it runs through the entire System Diagnostics and even takes a token away but then I get the:
Unauthorized to access Cisco IOS System Diagnostics. Authorization may have expired. Please re-login.
Yes. I'm logged in.
Suggestions??...
I have a customer that recently went from a Sup6 to a Sup8 on a 4506-E.
The problem I'm having and have a TAC case open for since Setpember is QoS implementation. When I apply QoS on a layer 3 WAN interface the WAN connection acts like someone too...
Wouldn't traffic change direction when doing failover? Therefore routing tables/arp entries would only populate on the active router and not the standby router?
Thanks,
Matt
"remote router ID was set to 0.0.0.0 where other sites had a 12.x.x.x ip assigned to it."
What do your logs show? Did you verify that ATT still has the same BGP ASN (65015) on their end? Can you ping your neighbor (12.84.112.53)?
Do the fol...
Enrico,
Thanks for the correction.
"HSRP version 2 does not interoperate with HSRP version 1. An interface cannot operate both version 1 and version 2 because both versions are mutually exclusive."
Sounds like he needs to make sure both ro...
HSRP V1 and V2 are compatible with each other. Group numbers have increased in V2 to 4095 from 255 in V1.
I would double check your configs again after checking out this LINK about conversion to V2. Although V1 and V2 are compatible it's someti...
