Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have run into a problem that have been struggling with. Recently a few locations have switched over to Meraki (Mx and MS) from a 2801. Before they were connecting via ATA adapters for the cordless phones, but now with the upgrade, these shouldnt be...
Ok Ill try and keep this as short as possible. Last week we had our MPLS service interrupted. Well once services were restored, all sites (we have 15 sites on MPLS) came back up except one. First thing I did was contact ATT. They were able to loo...
So, I was asked to create an extension that forwards to cell phone as this new hire does not have a workstation yet. Browsing around through forums, I saw someone mention create a translation pattern. I see we have some in place now, but not sure o...
Morning everyone. I have an extension that when dialed out, it is displayed as another. I have looked in DN config, and dont seem to find anything. Also searched for the extension being displayed, but it does not seem to exist in dir. One thing i...
So, there is a user at ext 1234 that is no longer with the company. Ops is requesting that ext (1234) have calls forwarded (which has been accomplished), and have access to that ext VM. Also would like for all incoming calls to ext 1234 be transfer...
So this is from a MPLS site thats currently up.
hou080-rt1#sh ip bgp neiBGP neighbor is 12.84.19.229, remote AS 7018, external link BGP version 4, remote router ID 12.122.124.240 <----Down site has this set to 0.0.0.0 this is what im confused on BGP ...
ATT didnt give me much info, and its hard to get in contact with dispatched techs on site for whatever reason, but what I am wondering about is that if other MPLS sites (which all touch base back home at corp office), each have a different "remote-r...
