Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know of a CLI command that I can enter on my WLC5508 running 8.2 code that will tell me the POE status of all connected APs? Specifically, whether or not any of the APs are only at 802.3af.
We will be replacing the APs soon with models ...
I have configured pbr on a 6500 that is not acting as I had expected. I need to change the next-hop address for traffic originating from vlan24 destined to the Internet. All other traffic should use the routing table on the 6500.Below is the config t...
