Retreive AP POE data from WLC CLI?

[jon.melancon]

Does anyone know of a CLI command that I can enter on my WLC5508 running 8.2 code that will tell me the POE status of all connected APs? Specifically, whether or not any of the APs are only at 802.3af.

We will be replacing the APs soon with models that do not support 802.3af and I would like to find and move the connections to a port capable of 802.3at prior to implementation.

I do know that I can use CDP and show power inline on the switches. I'm looking for a solution from the WLC.

[Flavio Miranda]

Hi @jon.melancon

The following command may help you:

show ap config general "AP"

Cisco AP Identifier.............................. 1
Cisco AP Name.................................... AP1
...
PoE Pre-Standard Switch.......................... Enabled
PoE Power Injector MAC Addr...................... Disabled
Power Type/Mode......................

-If I helped you somehow, please, rate it as useful.-