Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have to Cisco WS-C2960S-48TS-L on a stack. They're currently running IOS version is 15.0(2)SE6, C2960S-UNIVERSALK9-M.
The switch stack doesn't seem to be performing as expected.
Connections to devices behind the stack fail when member 1 is ma...
Hi,
I'm trying to configure Netflow on a Cisco 3925 runing IOS Version 15.0(1r)M8.
These are the Netflow commands I'm using
flow record NFRECORDmatch ipv4 source addressmatch ipv4 destination addressmatch ipv4 protocolmatch transport source-portma...
Hi,
I'm in the process of configuring a few VLANs in a WS-3650-48 switch. I'm a bit unsure about some of the logic that I'm using to create ACLs for in and out traffic in the VLAN interfaces.
Assume:
int vlan 10
ip address 192.168.100.0 255.255.25...
Hi,I'm configuring an Alienvault Unified Security Management (USM) unit and one of the requirements is setting up a SPAN port. The USM will be connected to a Cisco 3560X that is in the core of my network.I'm planning to configure a RSPAN session to c...
Hi,Currently my network has a Cisco 3825 performing all the vlan routing work. I have a Cisco 3560X behind it that could be configured as a full layer 3 switch, thus removing the need for the Cisco 3825 altogether or at least optimizing the functions...
Since it's Friday, I won't try any changes until early next week.
The current value for mac wait time persistency is set to "Indefinite"
#sh switchSwitch/Stack Mac Address : 1cde.a771.9280Mac persistency wait time: Indefinite ...
Just to add some more info here. I currently don't have persistent MAC address enabled. So it's possible that when the master switch goes down, the slave switch takes over ok, but the arp table in the L3 switch that this stack uplinks to still has th...
Does anyone have any input on this? Is the IOS I'm running an issue?
I tried a simpler config below, and my cache still shows empty
ip http timeout-policy idle 60 life 86400 requests 10000ip flow-export version 5ip flow-export destination x.x.x.x 9...
Sorry for the inconsistent info. I probably attempted to change the names in the post. Here's the output from the device
Tower_3925_1#sh flow exporterFlow Exporter NTAEXPORT: Description: User defined Export protocol: NetFlow ...
Masoud,
Thanks for the reply. I know how to configure the ACLs so the work for each interface. In fact, in the configurations that I'm considering, VLAN 10 and VLAN 20 will have their own ACLs because there'll be some rules that apply to one and not ...
